Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY: INSTALLATION
1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
(a) Check that the power switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Connect the airbag connector and install the clamp to the driver side knee airbag assembly.
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
(d) Push in the lock to install the airbag connector.
(e) Temporarily install the driver side knee airbag assembly with the 6 claws and 4 guides.
(f) Install the driver side knee airbag assembly with the 4 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
NOTICE:
Confirm that the driver side knee airbag assembly is installed securely without any excessive gaps and is not protruding outward.
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Installation
3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
5. INSTALL FRONT DOOR SCUFF PLATE LH Installation
6. INSTALL NO. 1 SWITCH HOLE BASE Installation
7. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Installation
8. INSTALL CONSOLE BOX ASSEMBLY Installation
9. INSTALL BOX BOTTOM MAT Installation
10. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation
11. INSTALL FRONT NO. 1 CONSOLE BOX INSERT Installation
12. INSTALL NO. 2 CONSOLE BOX MOUNTING BRACKET Installation
13. INSTALL ELECTRICAL KEY OSCILLATOR Installation
14. INSTALL SHIFT LOCK CONTROL UNIT ASSEMBLY Installation
15. INSTALL AIR CONDITIONING CONTROL ASSEMBLY Installation
16. INSTALL GLOVE COMPARTMENT DOOR Installation
17. INSTALL NO. 2 INSTRUMENT PANEL REGISTER Installation
18. INSTALL NO. 1 SIDE DEFROSTER NOZZLE Installation
19. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type) Installation
20. INSTALL NAVIGATION RECEIVER WITH BRACKET (for Navigation Receiver Type) Installation
21. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation
22. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation
23. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation
24. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY Installation
25. INSTALL REAR CONSOLE BOX ASSEMBLY
HINT
Refer to the procedure from Install Rear Console Box Assembly Installation.
26. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
27. INSTALL REAR NO. 3 FLOOR BOARD Installation
28. INSTALL REAR DECK FLOOR BOX Installation
29. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) Installation
30. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check DTC Check / Clear.
31. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.