Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT SEAT SIDE AIRBAG ASSEMBLY: INSTALLATION

HINT
* Use the same procedure for the LH side and RH side.
* The procedure listed below is for the LH side.

1. INSTALL FRONT SEAT AIRBAG ASSEMBLY

CAUTION:
* The nuts must not be reused.
* Make sure that the front seatback frame sub-assembly or separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.
(a) Install the front seat airbag assembly with 2 new nuts.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(b) Engage the 2 clamps.

2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat) Reassembly

3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat) Reassembly

4. CONNECT AIRBAG WIRE HARNESS (for Manual Seat)

(a) Engage the claw and 3 clamps to connect the airbag wire harness.

(b) Connect the 2 rubber bands of the separate type front seatback cover.

5. CONNECT AIRBAG WIRE HARNESS (for Power Seat)

(a) Engage the claw (D) and 3 clamps (C) to Connect the airbag wire harness.





(b) Engage the clamp (B).

(c) Connect the connector (A).

(d) w/ Seat Heater System:

(1) Connect the connector (E).

(2) Engage the clamp (F).

(e) Connect the 2 rubber bands of the separate type front seatback cover.

6. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat)

Installation

7. INSTALL FRONT SEAT ASSEMBLY (for Power Seat)

Installation

8. PERFORM DIAGNOSTIC SYSTEM CHECK

for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor

for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor