Installation

SEAT: FRONT SEAT ASSEMBLY (for Power Seat): INSTALLATION

1. INSTALL FRONT SEAT ASSEMBLY

(a) Place the front seat assembly in the cabin.

NOTICE:
Be careful not to damage the vehicle body.

(b) Connect each connector and clamp under the seat.

(c) Connect the cable to the negative (-) auxiliary battery terminal.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

(d) Temporarily install the front seat assembly with the 4 bolts.

(e) Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

(f) Tighten the 2 bolts on the front side of the seat.





Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

NOTICE:
Tighten the bolts in the order indicated in the illustration.

(g) Operate the slide and vertical power seat switch knob and move the seat to the foremost position.

(h) Tighten the 2 bolts on the rear side of the seat.





Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

NOTICE:
Tighten the bolts in the order indicated in the illustration.

2. INSTALL REAR INNER SEAT TRACK BRACKET COVER

(a) Engage the 2 claws to install the rear inner seat track bracket cover.

3. INSTALL REAR OUTER SEAT TRACK BRACKET COVER

(a) Engage the 2 claws to install the rear outer seat track bracket cover.

4. INSTALL FRONT SEAT HEADREST ASSEMBLY

5. INSTALL LUGGAGE TRIM SERVICE HOLE COVER Installation

6. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK (for Front Passenger Side)

Programming and Relearning

7. INSPECT FRONT SEAT ASSEMBLY

(a) Check the power seat operation Initial Inspection and Diagnostic Overview.

(b) w/ Seat Heater System:

Check the seat heater operation.

(1) Turn the power switch on (IG).

(2) Turn the seat heater switch on.

(3) Wait 5 minutes or more and confirm that the seat surface becomes warm.

8. INSPECT SRS WARNING LIGHT

for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor

for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor