Installation

SEAT: FRONT SEAT ASSEMBLY (for Manual Seat): INSTALLATION

1. INSTALL FRONT SEAT ASSEMBLY

(a) Place the front seat assembly in the cabin.

NOTICE:
Be careful not to damage the vehicle body.

(b) Connect each connector and clamp under the seat.

(c) Temporarily install the front seat assembly with the 4 bolts.

(d) Lift up the seat track adjusting handle and move the seat to the rearmost position.

(e) Tighten the 2 bolts on the front side of the seat.





Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

NOTICE:
Tighten the bolts in the order indicated in the illustration.

(f) Lift up the seat track adjusting handle and move the seat to the foremost position.

(g) Tighten the 2 bolts on the rear side of the seat.





Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

NOTICE:
Tighten the bolts in the order indicated in the illustration.

2. INSPECT SEAT SLIDE ADJUSTER LOCKS

(a) During the sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the seat installation bolts to adjust the adjuster position.

3. INSTALL REAR INNER SEAT TRACK BRACKET COVER

(a) Lift up the seat track adjusting handle and move the seat to the foremost position.

(b) Engage the 2 claws to install the rear inner seat track bracket cover.

4. INSTALL REAR OUTER SEAT TRACK BRACKET COVER

(a) Engage the 2 claws to install the rear outer seat track bracket cover.

5. INSTALL FRONT SEAT HEADREST ASSEMBLY

6. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization

7. INSTALL LUGGAGE TRIM SERVICE HOLE COVER Installation

8. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK (for Front Passenger Side)

Programming and Relearning

9. INSPECT SRS WARNING LIGHT

for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor

for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor