Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Using SST and a torque wrench, install the center airbag sensor assembly with the 3 bolts.





Text in Illustration





SST : 09961-00950

without SST - Torque : 18 Nm (178 kgf-cm, 13 ft-lbf)

with SST - Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)

NOTICE:
* Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
* This torque value is effective when SST is parallel to a torque wrench.
* If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
* When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
* When the power switch is first turned on (IG) after the center airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

(d) Connect the connectors to the center airbag sensor assembly as shown in the illustration.

NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

(e) Check that the waterproof sheet is properly set.

(f) Check that there is no looseness in the installation parts of the center airbag sensor assembly.

2. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Installation

3. INSTALL CONSOLE BOX ASSEMBLY Installation

4. INSTALL BOX BOTTOM MAT Installation

5. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation

6. INSTALL FRONT NO. 1 CONSOLE BOX INSERT Installation

7. INSTALL NO. 2 CONSOLE BOX MOUNTING BRACKET Installation

8. INSTALL ELECTRICAL KEY OSCILLATOR Installation

9. INSTALL SHIFT LOCK CONTROL UNIT ASSEMBLY Installation

10. INSTALL AIR CONDITIONING CONTROL ASSEMBLY Installation

11. INSTALL GLOVE COMPARTMENT DOOR Installation

12. INSTALL NO. 2 INSTRUMENT PANEL REGISTER Installation

13. INSTALL NO. 1 SIDE DEFROSTER NOZZLE Installation

14. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type) Installation

15. INSTALL NAVIGATION RECEIVER WITH BRACKET (for Navigation Receiver Type) Installation

16. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

17. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

18. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation

19. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY Installation

20. INSTALL REAR CONSOLE BOX ASSEMBLY

HINT
Refer to the procedure from Install Rear Console Box Assembly Installation.

21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

22. INSTALL REAR NO. 3 FLOOR BOARD Installation

23. INSTALL REAR DECK FLOOR BOX Installation

24. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) Installation

25. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check DTC Check / Clear.

26. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.