Installation
LIGHTING (EXT): REAR COMBINATION LIGHT ASSEMBLY: INSTALLATION
1. INSTALL REAR COMBINATION LIGHT ASSEMBLY
(a) Engage the guide and 2 clips, and install the rear combination light assembly as shown in the illustration.
CAUTION:
When installing the rear combination light assembly, check that the wire harness is not caught between the rear combination light assembly and the body. Failure to do so may cause a short circuit.
(b) Install the 2 nuts.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
(c) Connect the connector.
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) Installation
3. INSTALL TONNEAU COVER HOLDER CAP (for LH Side) Installation
4. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (for LH Side) Installation
5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) Installation
6. INSTALL TONNEAU COVER HOLDER CAP (for RH Side)
HINT
Use the same procedure described for the LH side.
7. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (for RH Side)
HINT
Use the same procedure described for the LH side.
8. INSTALL REAR SIDE SEATBACK ASSEMBLY LH (for LH Side) Installation
9. INSTALL REAR SIDE SEATBACK ASSEMBLY RH (for RH Side)
HINT
Use the same procedure described for the LH side.
10. INSTALL REAR SEAT CUSHION ASSEMBLY Installation
11. INSTALL REAR DECK TRIM COVER Installation
12. INSTALL DECK TRIM SERVICE HOLE COVER Installation
13. INSTALL REAR NO. 1 FLOOR BOARD Installation
14. INSTALL REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY Installation
15. INSTALL REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY Installation
16. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) Installation
17. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP Installation
18. INSTALL REAR DOOR SCUFF PLATE Installation
19. INSTALL DECK FLOOR BOX LH (for LH Side) Installation
20. INSTALL REAR NO. 4 FLOOR BOARD (for LH Side) Installation
21. INSTALL REAR NO. 3 FLOOR BOARD (for RH Side) Installation
22. INSTALL REAR DECK FLOOR BOX Installation
23. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) Installation
24. INSTALL REAR BUMPER ASSEMBLY Installation