Installation

THEFT DETERRENT / KEYLESS ENTRY: CERTIFICATION ECU: INSTALLATION

1. INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

(a) w/ ECU Integration Box RH:

(1) Engage the 2 claws and install the certification ECU (smart key ECU assembly).

(b) w/o ECU Integration Box RH:

(1) Install the certification ECU (smart key ECU assembly) with the nut and bolt.

(2) Connect each connector.

2. INSTALL ECU INTEGRATION BOX RH (w/ ECU Integration Box RH)

(a) Install the ECU integration box RH with the 2 nuts and bolt.

Nut - Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

Bolt - Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)

(b) Engage the clamp.

(c) Connect each connector.

3. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation

4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Installation

5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

6. INSTALL INSTRUMENT SIDE PANEL RH Installation

7. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH Installation

8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT
Use the same procedure for the RH side and LH side Installation.

9. INSTALL FRONT DOOR SCUFF PLATE RH

HINT
Use the same procedure for the RH side and LH side Installation.

10. INSTALL FRONT PANEL GARNISH RH Installation

11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

12. INSTALL LUGGAGE TRIM SERVICE HOLE COVER Installation

13. REGISTER KEY

NOTICE:
If the certification ECU (smart key ECU assembly) is replaced, refer to Registration Engine Immobilizer System.

14. INSPECT SRS WARNING LIGHT

* for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor

* for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor