Removal and Installation

Shift Cable and Selector Cable, Manual Transmission

Removing

- Remove shift mechanism. Refer to => [ Shift Mechanism, Manual Transmission ] Removal and Installation.

- Body Protectors, Installing. Refer to => [ Body Protectors, Installing ] Body Protectors, Installing.

- Remove the left engine compartment trim - 1 -.





- Remove the engine cover - 2 -.

- Remove the air filter housing.





- Push sleeve forward up to the stop - arrow 1 -.





• The procedure is identical when working on a shift cable or selector cable.

- Turn sleeve to the right up to the stop - arrow 2 - so that it engages.

- Remove the cable retainers from the shift or selector cable.

- Remove the lock washers - 1 and 2 -.





- Remove the selector cable from the cable mounting bracket.

• Ignore - arrows -.

- Remove the front noise insulation - 2 -.





- Free up the shift cables on the generator bracket - arrow -.





- Remove the center tunnel cover - 1 -.





- Remove the nut - arrow - and the retaining clamp.





- Remove the nut - 1 - and bolt - 2 - and remove the shift cables upward.





Installing

• Tightening specification. Refer to => [ Shift Cables, Manual Transmission Assembly Overview ] Description and Operation.

Install in reverse order, paying attention to the following:

- First guide the selector cable - 1 - (white) in and press it into the front opening - arrow -. Then guide the shift cable - 2 - (black) in.





- Install shift mechanism. Refer to => [ Shift Mechanism, Manual Transmission ] Removal and Installation.

- Adjust shift mechanism. Refer to => [ Shift Mechanism, Manual Transmission, Adjusting ] Adjustments.

- Install the front noise insulation.

- Install the air filter housing.

- Install the engine compartment trim.