Bi-Xenon HID Headlamps Assembly Overview

Bi-Xenon HID Headlamps Assembly Overview





1 Adjusting Nut

• For adjustment of headlamp to bumper contour

2 Headlamp Housing

• The daytime running lamps and parking lamps are LED lamps and are integrated in the headlamp housing. The LEDs cannot be replaced. The entire headlamp must be replaced.

• Removing and installing, refer to => [ HID Headlamp Housing ] HID Headlamp Housing

3 Screw

• 4.5 Nm

4 Daytime Running Lamp and Parking Lamp LED Module

• Left LED parking lamp/DRL module (L176)

• Right LED parking lamp/DRL module (L177)

• Removing and installing, refer to => [ LED Parking Lamp/Daytime Running Lamp Modules L176 and L177 ] Service and Repair

5 Screw

• 2 Nm

6 HID Headlamp Control Module

• Left high-intensity gas discharge lamp control module (J343)

• Right high-intensity gas discharge lamp control module (J344)

• Removing and installing, refer to => [ HID Lamp Control Module ] HID Lamp Control Module

7 Screw

• 2 Nm

8 Screw

• 4.5 Nm

9 Front Turn Signal Lamp

• Left front turn signal lamp (M5)

• Right front turn signal lamp (M7)

• 12 V, 21 W (H21W)

• Changing bulb, refer to => [ Front Turn Signal Lamp Bulbs ] Service and Repair

10 O-Ring

• from the turn signal cover repair set

11 Turn Signal Housing Cover

• Original equipment is a unit with the headlamp housing. Replace separately.

• Removing and installing, refer to => [ Front Turn Signal Lamp Bulbs ] Service and Repair

12 Screw

• From the turn signal cover repair set

• 2 Nm

13 Low Beam Housing Cover

14 Screw

• 2 Nm

15 Gas-Discharge Lamp

• With integrated ignition coil

• Left HID headlamp bulb (L13)

• Right HID headlamp bulb (L14)

• 35 W (D1S)

• Changing bulb, refer to => [ HID Headlamp Bulbs ] Service and Repair

16 Screw

• 4.5 Nm

17 Adjusting Nut

• For adjustment of headlamp to bumper contour