Removal
SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing Service Precautions.
2. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type) Removal
3. REMOVE REAR DECK FLOOR BOX Removal
4. REMOVE REAR NO. 3 FLOOR BOARD Removal
5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
6. REMOVE REAR CONSOLE BOX ASSEMBLY
HINT
Refer to the procedure up to Remove Rear Console Box Assembly Removal.
7. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY Removal
8. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Removal
9. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal
10. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Removal
11. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type) Removal
12. REMOVE NAVIGATION RECEIVER WITH BRACKET (for Navigation Receiver Type) Removal
13. REMOVE NO. 1 SIDE DEFROSTER NOZZLE Removal
14. REMOVE NO. 2 INSTRUMENT PANEL REGISTER Removal
15. REMOVE GLOVE COMPARTMENT DOOR Removal
16. REMOVE AIR CONDITIONING CONTROL ASSEMBLY Removal
17. REMOVE SHIFT LOCK CONTROL UNIT ASSEMBLY Removal
18. REMOVE ELECTRICAL KEY OSCILLATOR Removal
19. REMOVE NO. 2 CONSOLE BOX MOUNTING BRACKET Removal
20. REMOVE FRONT NO. 1 CONSOLE BOX INSERT Removal
21. REMOVE FRONT NO. 2 CONSOLE BOX INSERT Removal
22. REMOVE BOX BOTTOM MAT Removal
23. SEPARATE CONSOLE BOX ASSEMBLY Removal
24. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Removal
25. REMOVE CONSOLE BOX ASSEMBLY Removal
26. REMOVE CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the power switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect the connectors from the center airbag sensor assembly as shown in the illustration.
NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
(d) Remove the 3 bolts and center airbag sensor assembly.