Audio And Visual System (w/ Daytime Running Light)
AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM (w/ Daytime Running Light): B1579: Voice Recognition Microphone Disconnected
B1579 - Voice Recognition Microphone Disconnected
DESCRIPTION
The radio and display receiver assembly and map light assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.
This DTC is stored when a microphone connection detection signal line is disconnected.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY Removal
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))
(a) Disconnect the radio and display receiver assembly connector.
(b) Disconnect the map light assembly (telephone microphone assembly) connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
w/o Sliding Roof
w/ Sliding Roof
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. INSPECT MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
w/o Sliding Roof
w/ Sliding Roof
Text in Illustration
NG -- REPLACE TELEPHONE MICROPHONE ASSEMBLY
OK -- REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY Removal
4. REPLACE TELEPHONE MICROPHONE ASSEMBLY
(a) Replace the telephone microphone assembly (w/o Sliding Roof) Removal.
(b) Replace the telephone microphone assembly (w/ Sliding Roof) Removal.
(c) Clear the DTCs Audio And Visual System (w/ Daytime Running Light).
(d) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
NG -- REPLACE MAP LIGHT ASSEMBLY Removal
OK -- END