Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

1. INSTALL AIRBAG SENSOR ASSEMBLY

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

(c) Using SST, install the airbag sensor assembly with the 3 bolts.





Text in Illustration





SST : 09961-00950

without SST - Torque : 18 Nm (178 kgf-cm, 13 ft-lbf)

with SST - Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)

NOTICE:
* Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
* This torque value is effective when SST is parallel to a torque wrench.
* If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
* When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
* When the power switch is first turned on (IG) after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

(d) Connect the connectors to the airbag sensor assembly as shown in the illustration.





NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

(e) Check that the waterproof sheet is properly set.

Text in Illustration





(f) Check that there is no looseness in the installation parts of the airbag sensor assembly.

2. INSTALL NO. 1 CONSOLE BOX DUCT (w/ Rear Register Duct) Installation

3. INSTALL FLOOR CARPET BRACKET LH Installation

4. INSTALL FLOOR CARPET BRACKET RH Installation

5. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation

6. INSTALL CONSOLE BOX INSERT Installation

7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

8. INSTALL BOX BOTTOM MAT Installation

9. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation

10. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY Installation

11. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Installation

12. INSTALL INSTRUMENT SIDE PANEL LH Installation

13. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

14. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation

15. INSTALL FRONT DOOR SCUFF PLATE LH Installation

16. INSTALL REAR CONSOLE BOX ASSEMBLY

Installation

17. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Installation

18. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION (for Built-in Type Yaw Rate Sensor)

HINT
* When the airbag sensor assembly is replaced, perform zero point learning for the yaw rate and acceleration sensor Calibration.
* The yaw rate and acceleration sensor is built into the airbag sensor assembly.