Rear Seat Reclining Control Cable
SEAT: REAR SEAT RECLINING CONTROL CABLE: INSTALLATION
1. INSTALL REAR SEATBACK LOCK SUB-ASSEMBLY LH
(a) Install the rear seatback lock sub-assembly LH with the 2 nuts.
Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)
2. INSTALL REAR SEATBACK LOCK SUB-ASSEMBLY RH
(a) Install the rear seatback lock sub-assembly RH with the 2 nuts.
Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)
(b) Engage the hook as shown in the illustration.
3. INSTALL NO. 1 ROOM PARTITION BOARD
(a) Engage the 5 clips to install the No. 1 room partition board.
(b) Install the 4 clips.
4. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY Installation
5. INSTALL REAR SEAT SHOULDER BELT COVER Installation
6. INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR COVER Installation
7. INSTALL CENTER STOP LIGHT SET Installation
8. CONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH Installation
9. INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH Installation
10. CONNECT REAR SEAT OUTER BELT ASSEMBLY (for LH Side) Installation
11. CONNECT REAR SEAT OUTER BELT ASSEMBLY (for RH Side) Installation
12. INSTALL ROOF SIDE INNER GARNISH LH Installation
13. INSTALL ROOF SIDE INNER GARNISH RH
HINT
Use the same procedure as for the LH side Installation.
14. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH Installation
15. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation
16. INSTALL REAR SIDE SEATBACK ASSEMBLY LH Installation
17. INSTALL REAR SIDE SEATBACK ASSEMBLY RH Installation
18. INSTALL REAR SEATBACK ASSEMBLY LH Installation
19. INSTALL NO. 2 ROOM PARTITION COVER Installation
20. INSTALL REAR SEATBACK ASSEMBLY RH Installation
21. INSTALL REAR SEAT CUSHION LOCK HOOK Installation
22. INSTALL REAR SEAT CUSHION ASSEMBLY Installation
23. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
24. INSTALL LUGGAGE TRIM SERVICE HOLE COVER Installation
25. INSPECT SRS WARNING LIGHT
for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor
for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor