Installation

SEAT: REAR SEAT ASSEMBLY: INSTALLATION

1. INSTALL REAR SIDE SEATBACK ASSEMBLY LH

(a) Engage the hook to install the rear side seatback assembly LH.

(b) Install the 2 bolts.

Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)

(c) Connect the connector.

(d) Connect the rear seat outer belt to the rear seat shoulder belt guide LH.

2. INSTALL REAR SIDE SEATBACK ASSEMBLY RH

(a) Engage the hook to install the rear side seatback assembly RH.

(b) Install the 2 bolts.

Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)

(c) Connect the connector.

(d) Connect the rear seat outer belt to the rear seat shoulder belt guide RH.

3. INSTALL REAR SEATBACK ASSEMBLY LH

(a) Place the rear seatback assembly LH in the cabin.

NOTICE:
Be careful not to damage the vehicle body.

(b) Install the rear seatback assembly LH with the 2 bolts.

Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)

(c) Connect the rear seat inner with center belt assembly LH to the rear seat center shoulder belt guide.

4. INSTALL NO. 2 ROOM PARTITION COVER

(a) Engage the guide and claw to install the No. 2 room partition cover.





5. INSTALL REAR SEATBACK ASSEMBLY RH

(a) Place the rear seatback assembly RH in the cabin.

NOTICE:
Be careful not to damage the vehicle body.

(b) Install the rear seatback assembly RH with the 2 bolts.

Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)

6. INSTALL REAR SEAT CUSHION LOCK HOOK

(a) Engage the claw to install a new rear seat cushion lock hook.





NOTICE:
Rear seat cushion lock hooks must not be reused.

HINT
Use the same procedure for the RH side and the LH side.

7. INSTALL REAR SEAT CUSHION ASSEMBLY

(a) Place the rear seat cushion assembly in the cabin.

NOTICE:
Be careful not to damage the vehicle body.

(b) Engage the 2 hooks of the seat cushion to the vehicle body as shown in the illustration.





(c) Confirm that the seat cushion is firmly installed.

NOTICE:
When installing the seat cushion, make sure that the seat belt buckles are not under the seat cushion.

8. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

9. INSTALL LUGGAGE TRIM SERVICE HOLE COVER Installation

10. INSPECT SRS WARNING LIGHT

for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor

for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor