CKP Pulse Plate Replacement

CKP Pulse Plate Replacement

1. Remove the front wheels.

2. Remove the front undercover and the splash shield Engine Removal.

3. Remove the drive belt Service and Repair.

4. Turn the crankshaft pulley so its top dead center (TDC) mark lines up with the pointer Adjustments.

5. Remove the water pump pulley Service and Repair.

6. Remove the cylinder head cover Cylinder Head Cover Removal.

7. Remove the crankshaft pulley Service and Repair.

8. Remove the oil pan Engine Oil Pan Removal.

9. Lift and support the engine with a jack and a wood block under the engine block.

10. Remove the ground cable, then remove the side engine mount bracket Cam Chain Removal.

11. Disconnect the CKP sensor connector, then remove the harness clamp and the dipstick tube mounting bolt Cam Chain Removal.

12. Remove the chain case Cam Chain Removal.

13. Remove the CKP pulse plate (A).






14. Install the CKP pulse plate.

15. Check the chain case oil seal for damage. If the oil seal is damaged, replace the chain case oil seal Service and Repair.

16. Remove all of the old liquid gasket from the chain case mating surfaces, the bolt, and the bolt holes.

17. Clean and dry the chain case mating surfaces.

18. Apply liquid gasket, P/N 08717-0004, 08718-0003 or 08718-0009, to the cylinder head and the engine block mating surface of the chain case, and to the inside edge of the threaded bolt holes. Install the component within 5 minutes of applying the liquid gasket Cam Chain Installation.

NOTE:

- Apply a 1.5 mm (0.059 in) diameter bead of liquid gasket along the broken lines (A).
- Apply a 3.0 mm (0.118 in) diameter bead of liquid gasket to the engine block upper surface mating areas on the chain case.
- If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
- If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.

19. Install the chain case Cam Chain Installation.

20. Install the harness clamps and the dipstick tube mounting bolt, then connect the CKP sensor connector Cam Chain Installation.

21. Install the side engine mount bracket, then loosely install the mount mounting bolts and nut Engine Installation.

22. Install the ground cable Engine Installation.

23. Loosen the transmission mount bracket support bolt and nuts.

24. Remove the jack and the wood block.

25. Loosen the lower torque rod mounting bolts.

26. Tighten the side engine mount bracket mounting bolts and nut in the numbered sequence shown.

27. Tighten the transmission mount bracket support bolt and nuts.

28. Tighten the lower torque rod mounting bolts in the numbered sequence.

29. Install the oil pan Engine Oil Pan Installation.

30. Install the crankshaft pulley Service and Repair.

31. Install the cylinder head cover Cylinder Head Cover Installation.

32. Install the water pump pulley Service and Repair.

33. Install the drive belt Service and Repair.

34. Install the splash shield and the front undercover Engine Installation.

35. Install the front wheels.

36. Do the CKP pattern clear/CKP pattern learn procedure Initial Inspection and Diagnostic Overview.