Luggage Compartment Floor Trim

Luggage Compartment Floor Trim

Audi A8 Hybrid

Removing






- Remove the luggage compartment side trim. Refer to => [ Luggage Compartment Side Trim Panel ] Luggage Compartment Side Trim Panel.

- Remove tie-down eyes - 1, 3 - => [ Tie Down ] Tie Down.

- Lift up luggage compartment floor mat by the handle and attach handle on the rear lid seal.

- Pull luggage compartment floor trim - 2 - back and remove.

Installing

Install in reverse order of removal. Note the following:

Installation note: For example tightening specifications, replace components => [ Luggage Compartment Floor Covering Assembly Overview ] Luggage Compartment Floor Covering Assembly Overview.

Audi A8 Hybrid

Risk of unintended engine start

For all work on high voltage vehicles, turn off the ignition and keep the key outside of the vehicle interior.

There is a risk of being electrocuted if high voltage components are damaged.

When working near high voltage components and wires, observe the following:

• Do not use cutting, deforming, sharp-edged tools or heat sources such as welding, solder, hot air or thermal glue.

• Perform a visual inspection before beginning any work in the area of high voltage components.

• Perform a visual inspection of the electric drive power and control electronics (JX1) , the vehicle electric drive (V141) , the A/C compressor (V470) and the high voltage lines when working in the engine compartment.

• Perform a visual inspection of the high voltage cable and the cover when working on the floor panel.

• Visually inspect the high voltage cables, the electronics and the high voltage system maintenance connector (TW) , when working in the luggage compartment.

• Perform a visual inspection of all of the potential equalization cables.

Note the following when performing a visual inspection:

• No components should show any signs of exterior damage.

• The high voltage cable insulation and potential equalization cable insulation must not be damaged.

• The high voltage cables must not be deformed in any way.

• Every high voltage component must be marked with a red warning label.

Removing






- Remove the luggage compartment liner => [ Audi A8 Hybrid ] Luggage Compartment Liner.

- Remove the rear cross panel trim. Refer to => [ Rear Cross Panel Trim ] Rear Cross Panel Trim.

- Remove the luggage compartment side trim, refer to => [ Luggage Compartment Side Trim Panel ] Luggage Compartment Side Trim Panel.

- Remove the tie down - 1 -. Refer to => [ Tie Down ] Tie Down.

- Remove the luggage compartment trim piece - 2 -.

Installing

Install in reverse order of removal. Note the following: