Luggage Compartment Liner

Luggage Compartment Liner

Audi A8 Hybrid

Removing






- Remove luggage compartment rear panel trim. Refer to => [ Luggage Compartment Rear Panel Trim ] Luggage Compartment Rear Panel Trim.

- Detach luggage compartment floor covering - 1 - in the front - arrows - and remove it.

Installing

Install in reverse order of removal. Note the following:

Installation note: For example tightening specifications, replace components => [ Luggage Compartment Floor Covering Assembly Overview ] Luggage Compartment Floor Covering Assembly Overview.

Audi A8 Hybrid

Risk of unintended engine start

For all work on high voltage vehicles, turn off the ignition and keep the key outside of the vehicle interior.

There is a risk of being electrocuted if high voltage components are damaged.

When working near high voltage components and wires, observe the following:

• Do not use cutting, deforming, sharp-edged tools or heat sources such as welding, solder, hot air or thermal glue.

• Perform a visual inspection before beginning any work in the area of high voltage components.

• Perform a visual inspection of the electric drive power and control electronics (JX1) , the vehicle electric drive (V141) , the A/C compressor (V470) and the high voltage lines when working in the engine compartment.

• Perform a visual inspection of the high voltage cable and the cover when working on the floor panel.

• Visually inspect the high voltage cables, the electronics and the high voltage system maintenance connector (TW) , when working in the luggage compartment.

• Perform a visual inspection of all of the potential equalization cables.

Note the following when performing a visual inspection:

• No components should show any signs of exterior damage.

• The high voltage cable insulation and potential equalization cable insulation must not be damaged.

• The high voltage cables must not be deformed in any way.

• Every high voltage component must be marked with a red warning label.

Removing






- Unclip the front corners of the luggage compartment floor covering - 1 - - arrows - and remove it.

Installing

Install in reverse order of removal. Note the following:

Installation note: For example tightening specifications, replace components => [ Audi A8 Hybrid ] Luggage Compartment Floor Covering Assembly Overview