Checking Signal to Combination Relay [GA2]

Checking Signal To Combination Relay





- Ignition on.
- Disconnect combination relay 15-pin connector.
- Disconnect control module.

Connect a voltmeter between combination relay 15-pin connector terminal 6 and ground.

Voltmeter should read approx. battery voltage.

If reading is OK:
- Check lead between connector 24/13:44 and control module #52 for open circuit as per HA2. Open Circuit [HA2]

If reading is incorrect:
- Check that light bulb in dashboard is intact and check lead between connector 24/13:44 and dashboard terminal B:6 for open circuit as per HA2. Open Circuit [HA2]

- If light bulb and lead are OK, try another dashboard.