Installation

WIPER / WASHER: REAR WIPER MOTOR: INSTALLATION

1. INSTALL REAR WIPER MOTOR ASSEMBLY

(a) Install the rear wiper motor assembly with the 3 bolts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

(b) Connect the connector.

2. INSTALL BACK DOOR TRIM BOARD Reassembly

3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY Reassembly

4. INSTALL BACK DOOR SIDE GARNISH LH Reassembly

5. INSTALL BACK DOOR SIDE GARNISH RH Reassembly

6. INSTALL UPPER BACK DOOR TRIM PANEL ASSEMBLY Reassembly

7. INSTALL REAR WIPER MOTOR GROMMET

(a) Apply MP grease to the entire surface of the rear wiper motor grommet lip.

Text in Illustration

HINT
Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

(b) Install the rear wiper motor grommet.

HINT
Install the grommet with its alignment mark facing up.

Text in Illustration

8. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

(a) Operate the wiper and stop the windshield wiper motor at the automatic stop position.

(b) When reusing the rear wiper arm and blade assembly:

(1) Clean the wiper arm serrations.

Text in Illustration

(d) Install the rear wiper arm and blade assembly with the nut to the position shown in the illustration.

Text in Illustration

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

HINT
Hold the wiper arm by hand while tightening the nut.

(e) Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.

9. INSTALL REAR WIPER ARM HEAD CAP

(a) Engage the 2 claws to install the rear wiper arm head cap.

(b) Engage the 2 claws to close the rear wiper arm head cap as shown in the illustration.