Installation
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION
1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
(a) Engage the guide to temporarily install the front shoulder belt anchor adjuster assembly with the 2 bolts.
(b) Fully tighten the bolt first, then the bolt to install the front shoulder belt anchor adjuster assembly.
Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY
(a) Temporarily install the front seat outer belt assembly with the 2 bolts.
(b) Fully tighten the bolt first, then the bolt to install the front seat outer belt assembly.
<>
Bolt A - Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)
<>
Bolt B - Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
(c) Connect the connector and lock the locking button as shown in the illustration.
NOTICE:
Securely lock the locking button.
(d) Connect each connector.
(e) Connect the shoulder anchor of the front seat outer belt assembly with the nut.
Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
3. INSTALL CENTER PILLAR GARNISH Installation
4. INSTALL CENTER PILLAR LOWER GARNISH Installation
5. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH Installation
6. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH Installation
7. CONNECT FRONT SEAT OUTER BELT ASSEMBLY
(a) Install the floor end of the front seat outer belt assembly with the bolt.
Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
(b) Check if the ELR locks.
NOTICE:
The check should be performed with the outer belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.
8. INSTALL LAP BELT OUTER ANCHOR COVER
(a) Engage the 3 claws to install the lap belt outer anchor cover.
9. INSTALL REAR DOOR SCUFF PLATE Installation
10. INSTALL FRONT DOOR SCUFF PLATE Installation
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
12. INSTALL REAR NO. 3 FLOOR BOARD Installation
13. INSTALL REAR DECK FLOOR BOX Installation
14. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) Installation
15. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.