Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Temporarily install the curtain shield airbag assembly with the 5 hooks.





NOTICE:
Do not twist the curtain shield airbag assembly when installing it.

(d) Install the curtain shield airbag assembly to the body panel with 4 new clips and 4 new spacers.





(1) Install 4 new pins as shown in the illustration.





Text in Illustration





NOTICE:
Make sure that the pins of the clips are pushed in firmly.

(e) Install the 5 bolts.





Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

(f) Connect the curtain shield airbag connector.





NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

(g) Push in the lock to install the airbag connector.

2. INSTALL ROOF HEADLINING ASSEMBLY

HINT
Refer to the procedure from Install Roof Headlining Assembly Installation.

3. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check DTC Check / Clear.