Removal

HEATING / AIR CONDITIONING: CONDENSER: REMOVAL

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM Service and Repair

3. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type) Removal

4. REMOVE REAR DECK FLOOR BOX Removal

5. REMOVE REAR NO. 3 FLOOR BOARD Removal

6. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

7. REMOVE FRONT BUMPER ASSEMBLY

Removal

8. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) Removal

9. REMOVE MILLIMETER WAVE RADAR SENSOR BRACKET (w/ Dynamic Radar Cruise Control System)

(a) Remove the bolt and millimeter wave radar sensor bracket.





10. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

(a) Remove the bolt and disconnect the discharge hose sub-assembly.





(b) Remove the O-ring from the discharge hose sub-assembly.

NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

11. DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY

(a) Remove the bolt and disconnect the air conditioning tube and accessory assembly.





(b) Remove the O-ring from the air conditioning tube and accessory assembly.

NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

12. DISCONNECT NO. 5 INVERTER COOLING HOSE

(a) Using pliers, grip the claws of the clip and slide the clip to disconnect the No. 5 inverter cooling hose.





NOTICE:
* Do not apply excessive force to the No. 5 inverter cooling hose.
* Prepare a drain pan or cloth in case the coolant leaks.

13. DISCONNECT NO. 7 INVERTER COOLING HOSE

(a) Using pliers, grip the claws of the clip and slide the clip to disconnect the No. 7 inverter cooling hose.





NOTICE:
* Do not apply excessive force to the No. 7 inverter cooling hose.
* Prepare a drain pan or cloth in case the coolant leaks.

14. REMOVE NO. 1 INVERTER BRACKET Removal

15. REMOVE HOOD LOCK SUPPORT SUB-ASSEMBLY Removal

16. REMOVE NO. 2 FAN SHROUD Removal

17. REMOVE COOLER CONDENSER ASSEMBLY

(a) Remove the cooler condenser assembly with hybrid radiator assembly.





(b) Remove the 4 bolts and cooler condenser assembly from the hybrid radiator assembly.