Installation

SEAT: FRONT SEAT ASSEMBLY (for Power Seat): INSTALLATION

1. INSTALL FRONT SEAT ASSEMBLY

(a) Place the front seat assembly in the cabin.

NOTICE:
Be careful not to damage the vehicle body.

(b) Connect the connectors under the seat.

(c) Connect the cable to the auxiliary negative (-) battery terminal.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

(d) Temporarily install the front seat assembly with the 4 bolts.

(e) Operate the power seat switch knob and move the seat to the rearmost position.

(f) Tighten the 2 bolts on the front side of the seat.





Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

NOTICE:
Tighten the bolts in the order indicated in the illustration.

(g) Operate the power seat switch knob and move the seat to the foremost position.

(h) Tighten the 2 bolts on the rear side of the seat.





Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

NOTICE:
Tighten the bolts in the order indicated in the illustration.

2. INSTALL INNER SEAT TRACK BRACKET COVER

(a) Engage the guide and claw to install the inner seat track bracket cover.

3. INSTALL OUTER SEAT TRACK BRACKET COVER

(a) Engage the 2 claws to install the outer seat track bracket cover.

4. INSTALL FRONT SEAT HEADREST ASSEMBLY

5. INSTALL REAR NO. 3 FLOOR BOARD Installation

6. INSTALL REAR DECK FLOOR BOX Installation

7. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) Installation

8. INSPECT FRONT SEAT ASSEMBLY

(a) Check the power seat operation Initial Inspection and Diagnostic Overview.

(b) Check the seat heater operation.

(1) Turn the power switch on.

(2) Turn the seat heater switch on.

(3) Wait 5 minutes or more and confirm that the seat surface becomes warm.

9. INSPECT SRS WARNING LIGHT

Diagnosis System