Removal

2AR-FXE INTAKE / EXHAUST: INTAKE MANIFOLD: REMOVAL

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Service Precautions.

2. DISCHARGE FUEL SYSTEM PRESSURE

Service Precautions

3. REMOVE LUGGAGE TRIM SERVICE HOLE COVER Removal

4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

Removal

6. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Removal

7. REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY Removal

8. REMOVE EGR VALVE ASSEMBLY Removal

9. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR Removal

10. SEPARATE INTAKE MANIFOLD

(a) Disconnect the No. 2 ventilation hose.





(b) Disconnect the heated oxygen sensor connector.





(c) Disconnect the 6 wire harness clamps.





(d) Remove the 6 bolts to separate the intake manifold from the engine assembly.





11. DISCONNECT FUEL TUBE SUB-ASSEMBLY Removal

12. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY Removal

13. REMOVE INTAKE MANIFOLD

(a) Remove the intake manifold from the vehicle.

(b) Remove the gasket from the intake manifold.





(c) Remove the bolt and wire harness clamp bracket.





(d) Remove the vacuum hose from the intake manifold.





(e) Remove the fuel vapor feed hose from the intake manifold.