Removal

2AR-FXE ENGINE CONTROL: THROTTLE BODY: REMOVAL

1. DRAIN COOLANT (for Engine) Coolant (for Engine)

2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Removal

3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

(a) Disconnect the mass air flow meter connector and wire harness clamp from the air cleaner cap sub-assembly.





(b) Disconnect the ventilation hose from the cylinder head cover.

(c) Disconnect the connector and wire harness clamp.

(d) Release the 2 clamps and remove the air cleaner cap sub-assembly.





(e) Disconnect the 2 fuel vapor feed hoses.





Text in Illustration





NOTICE:
* Remove any dirt or foreign matter on the fuel tube connector before performing this work.
* Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the fuel tube connector has an O-ring that seals the pipe.
* Perform this work by hand. Do not use any tools.
* Protect the disconnected parts by covering them with plastic bags after disconnecting each fuel vapor feed hose.

(f) Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.





4. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

(a) Disconnect the 2 hoses.





(b) Disconnect the throttle body connector.





(c) Disconnect the 2 water by-pass hoses from the throttle with motor body assembly.

(d) Remove the 4 bolts and the throttle body with fuel tube bracket.





(e) Remove the gasket from the intake manifold.