Operation CHARM: Car repair manuals for everyone.
Hosted by mcallihan.com

Installation








2AZ-FE CHARGING: GENERATOR:

INSTALLATION

1. INSTALL GENERATOR ASSEMBLY





(a) Confirm that the wire harness of the crankshaft position sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.





(b) Install the generator assembly with the 2 bolts.
Bolt A - Torque: 21 Nm (215 kgf-cm, 15 ft-lbf)
Bolt B - Torque: 52 Nm (530 kgf-cm, 38 ft-lbf)





(c) Install the generator wire to terminal B with the nut.
Torque: 9.8 Nm (100 kgf-cm, 87 in-lbf)
(d) Install the clamp bracket with the bolt.
Torque: 8.4 Nm (86 kgf-cm, 74 in-lbf)
(e) Attach the clamp and connect the generator connector to the generator.
2. INSTALL FAN AND GENERATOR V BELT (Installation)

3. INSTALL NO. 2 ENGINE MOUNTING BRACKET RH (Installation)

4. INSTALL NO. 2 ENGINE MOUNTING STAY RH (Installation)

5. INSTALL ENGINE MOVING CONTROL ROD WITH BRACKET (Installation)

6. INSTALL FRONT WHEEL RH (Installation)

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. PERFORM INITIALIZATION

HINT: (Repair Instruction - Initialization)