Air Intake Duct Removal/Installation
AIR INTAKE DUCT REMOVAL/INSTALLATION
1. Set the air intake mode to REC.
2. Disconnect the negative battery cable.
3. Remove the following parts:
a. Glove compartment Service and Repair
b. Dashboard under cover Dashboard Under Cover Removal/Installation
c. Heat duct (RH) Heater Duct Component Removal/Installation
d. Rear console Rear Console Removal/Installation
e. Shift lever knob (MTX) Service and Repair
f. Side wall Side Wall Removal/Installation
g. Front console component Front Console Component Removal/Installation
h. Front scuff plate Front Scuff Plate Removal/Installation
i. Front side trim Front Side Trim Removal/Installation
j. Hood release lever Service and Repair
k. Lower panel (driver-side) Lower Panel Removal/Installation
l. Knee bolster Knee Bolster Removal/Installation
m. Driver-side air bag module Driver-Side Air Bag Module Removal/Installation
n. Steering wheel Service and Repair
o. Column cover Service and Repair
p. Meter hood Meter Hood Removal/Installation
q. Instrument cluster Removal and Replacement
r. Combination switch Removal and Replacement
s. Center panel unit Center Panel Unit Removal/Installation
t. Climate control unit Removal and Replacement
u. Shift lever component (MTX) Service and Repair
v. Selector lever component (ATX) Service and Repair
w. Interlock unit (ATX) Service and Repair
x. Lower panel (passenger-side) Lower Panel Removal/Installation
y. Side panel Side Panel Removal/Installation
z. A-pillar trim A-Pillar Trim Removal/Installation
aa. Windshield wiper arm and blade Windshield Wiper Arm And Blade Removal/Installation
ab. Cowl grille Cowl Grille Removal/Installation
ac. Windshield wiper motor Windshield Wiper Motor Removal/Installation
ad. Sail garnish Service and Repair
ae. Steering shaft cover Service and Repair
af. Steering shaft Service and Repair
4. Disconnect the dashboard wiring harness connector.
5. Disconnect the antenna feeder No.1 jack.
6. Remove the dashboard. Dashboard Removal/Installation
7. Remove the air intake duct installation bolt.
8. Remove the air intake duct.
9. Install in the reverse order of removal.