CONSULT-II / Self-Diagnosis
Self-DiagnosisOPERATION PROCEDURE
1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which performs CAN communication.
3. Turn ignition switch ON.
4. Start engine and drive vehicle at 30 km/h (19 MPH) or more for approximately 1 minute.
5. After stopping vehicle, with the engine running, touch START (NISSAN BASED VHCL), ABS, SELF-DIAG RESULTS in order on the CONSULT-II screen.
CAUTION: If START (NISSAN BASED VHCL) is touched immediately after starting engine or turning on the ignition switch, ABS might not be displayed in the SELECT SYSTEM screen. In this case, repeat the operation from step 1.
6. The self-diagnostic results are displayed. (Touch PRINT to print out self-diagnostic results, if necessary)
^ Check ABS warning lamp, VDC OFF indicator lamp and SLIP indicator lamp if NO FAILURE is displayed.
7. Perform the appropriate inspection from display item list, and repair or replace the malfunctioning component. Refer to DISPLAY ITEM LIST. Display Item List
8. Start engine and drive vehicle at 30 km/h (19 MPH) or more for approximately 1 minute.
CAUTION: When the wheel sensor malfunctions, after inspecting the wheel sensor system, the ABS warning lamp, VDC OFF indicator lamp, SLIP indicator lamp and brake warning lamp will not turn off even when the system is normal unless the vehicle is driving at approximately 30 km/h (19 MPH) or more for approximately 1 minute.
