Cooling Fan and Shroud Replacement

Cooling Fan and Shroud Replacement

Removal Procedure




1. Remove the air cleaner resonator outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement (Service and Repair)
2. Disengage the radiator inlet hose clip (2) at the fan shroud.




3. If necessary, reposition the surge tank inlet hose clamp at the radiator.
4. If necessary, remove the surge tank inlet hose from the radiator.




5. Disconnect the electrical connectors from the cooling fans.
6. Remove the clip attaching the wiring harness to the shroud.
7. Unclip the transmission cooler lines from fan shroud.




8. If necessary, open the engine oil cooler line clip and remove the cooler lines from the clip.




9. Unclip upper radiator inlet hose from fan shroud and reposition.
10. Remove the cooling fan shroud bolts.
11. Remove the cooling fan and shroud.

Installation Procedure





Note: Insert the 3 lower tabs into the radiator support flange. Keeping the shroud parallel to the radiator will ensure the correct installation of the lower tabs.

1. Install the cooling fan and shroud.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the cooling fan shroud bolts.

Tighten the bolts to 9 Nm (80 lb in).

3. Clip the upper radiator inlet hose to the fan shroud




4. If equipped, install the cooler lines to the clip and close the clip.




5. Connect the electrical connectors to the cooling fans.
6. Install the clip attaching the wiring harness to the shroud.
7. Clip the transmission cooler lines to the fan shroud.

Tighten the bolts to 4 Nm (35 lb in).




8. If necessary, install the surge tank inlet hose to the radiator.
9. If necessary, reposition the surge tank inlet hose clamp at the radiator.




10. Engage the radiator inlet hose clip (2) at the fan shroud.
11. Install the air cleaner resonator outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement (Service and Repair)