Rear Bumper Cover Assembly Overview

Rear Bumper Cover Assembly Overview

If the vehicle has lane change assist, calibrate the lane change assistance control module (J769) / (J770).






1 Bumper cover lower section

• Different versions, refer to => Electronic Parts Catalog

• Removing and Installing, refer to => [ Bumper Cover Lower Section ] Bumper Cover Lower Section

2 Rear bumper cover

• Removing and Installing, refer to => [ Rear Bumper Cover ] Rear Bumper Cover

3 Bolt

• 2 Nm

4 Bolt

• Quantity: 3

• Tightening sequence => [ Bumper Cover Side Mount - Tightening Specification and Sequence ]

5 Side mount

• For the bumper cover

• Removing and Installing, refer to => [ Bumper Cover Side Mount ] Bumper Cover Side Mount

6 Rear parking aid sensor

7 Locking rail

• For the bumper cover

8 Upper mount

• For the bumper cover

• Removing and Installing, refer to => [ Upper Bumper Cover Mount ] Upper Bumper Cover Mount

9 Bolt

• Quantity: 3

• Tightening sequence => [ Bumper Cover Upper Mount - Tightening Specification and Sequence ]

10 Lane change assistance control module

11 Rear parking aid sensor

12 Center mount

• For the bumper cover

• Removing and Installing, refer to => [ Center Bumper Cover Mount ] Center Bumper Cover Mount

13 Nut

• Quantity: 2

• Tightening sequence => [ Bumper Cover Center Mount - Tightening Specification and Sequence ]

14 Bumper cover trim

• Removing and Installing, refer to => [ Bumper Cover Trim ] Bumper Cover Trim

15 Cover

• For the towing eye

16 Bolt

• Vehicles without a trailer hitch: 3 bolts

• Vehicles with a trailer hitch: 2 bolts

• 1.7 Nm

Bumper Cover Upper Mount - Tightening Specification and Sequence





- Tighten the bolts in a - 1 to 3 - sequence to 2 Nm.

Bumper Cover Center Mount - Tightening Specification and Sequence





- Tighten the nuts to 1.5 Nm in the following sequence: - 1 and 2 -.

Bumper Cover Side Mount - Tightening Specification and Sequence





- Tighten the bolts in a - 1 to 3 - sequence to 2 Nm.