Center Differential Housing and Center Differential Overview

Center Differential Housing and Center Differential Overview

• Removal can also be performed with the transmission still installed.






1 Bolt

• 24 Nm

• Steel bolts (M8; 63 mm long)

• Quantity: 2

2 Center Differential Housing

• With or without vibration dampener, depending on version

• Removing and installing, refer to => [ Transmission ] Transmission

• For servicing, refer to => [ Center Differential Housing ] Center Differential Housing

3 Bolt

• Always replace

• 10 Nm plus an additional 90° turn

• Aluminum bolts (M8; 42 mm long)

• Quantity: 11

4 Pressure Spring

5 Plate Spring

• Installed position: The camber on the inner diameter faces the center differential housing

6 Adjusting Shim

• For bearing pre-loading the ball bearings for the center differential

• To select the correct thickness, refer to => [ Bearing Pre-load for Ball Bearings for the Center Differential, Redetermining ] Bearing Pre-Load For Ball Bearings For the Center Differential, Redetermining

7 Center Differential

• Servicing only by the manufacturer

• Center differential bearing, servicing, refer to => [ Spur Gear and Center Differential Bearing ] Spur Gear and Center Differential Bearing

8 Spacer Sleeve

9 Gear Carrier

• Pay attention to the installed position to the transmission cover => [ gear carrier on the transmission cover as follows: ] Transmission

10 Output Wheel/Drive Wheel

11 Transmission Cover / Transmission