Shift Cable: Service and Repair

Selector Lever Cable

Special tools, testers and auxiliary items required

• Pry lever (80-200)

Removing

• Before removing selector lever cable, secure a cable on selector lever cable so that it can be threaded easily when installing.

- Remove selector mechanism function unit => [ Selector Mechanism Unit ] Selector Mechanism Unit.

- Press boot - arrow - forward out of selector mechanism shift unit.





- Remove screws and remove rear noise insulation - 2 -.





- Pry out selector lever cable ball head - 2 - from selector shaft lever using Pry Lever (80-200).





- Remove securing clips - 1 - and remove selector lever cable from transmission.

• Do not bend or kink the selector lever cable.

Installing

Install in reverse order of removal, note the following:

Torque specifications: => [ Selector Lever Cable, Assembly Overview ] Description and Operation

- Secure selector lever cable to cable that was guided in during removal.

- Guide selector lever cable with boot - 2 - into selector mechanism shift unit - 1 -.





Selector shaft lever must not be bent when pressing selector lever cable on, counterhold if necessary.

- Carefully press selector lever cable - 2 - off selector shaft lever.





- Secure selector lever cable sleeve to bracket with new securing clip - 1 -.

- Carefully insert boot - arrow - all around in selector mechanism shift unit.





- Install shift mechanism function unit => [ Selector Mechanism Unit ] Selector Mechanism Unit.

- Adjust selector lever cable => [ Selector Lever Cable, Adjusting ] Adjustments

Torque specification