Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Checking components




- Ignition off.
Check the cable between the control module's connector B2#12(#A12) and the wiper motor's connector #4 for open circuit, contact resistance, and oxidation. Checking wiring and terminals. Intermittent faults Checking Wiring And Terminals. Intermittent Faults
Check that the wiper motor and wiper arms do not bind.

Hint: The trouble code may have been caused by wiper blades frozen stuck.

If no fault is found, try with a new wiper motor.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting The Breakout Box. Central Electronic Module (CEM)
- Signal specification Signal Specification. Central Electronic Module (CEM)
- To access/replace the wiper motor, see: Windshield washer / wiper mechanism and motor Windshield Washer/Wiper Mechanism And Motor









Välj Fortsätt.

Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking components

FAULT FOUND - DONE

-------------------------------------------------