Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking components




- Ignition off.
Check that the wiper motor and wiper arms do not bind.

Hint: The trouble code may have been caused by wiper blades frozen stuck.

If no fault is found, try with a new wiper motor.
Remedy as necessary.

Other information
- Signal specification Signal Specification. Central Electronic Module (CEM)
- To access/replace the wiper motor, see: Windshield washer / wiper mechanism and motor Windshield Washer/Wiper Mechanism And Motor





Select Continue.

Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking components

FAULT FOUND - DONE

-------------------------------------------------