Clutch, Removing

Clutch, Removing

In order to remove and install the clutch, transmission must be secured firmly in vertical position on assembly stand.

- Remove clutch cap => [ Clutch Cap ] Clutch Cap

- Remove securing ring - arrow - for clutch cap - 1 -.





- Remove clutch cap from clutch.

- Remove securing ring - arrow -.





• This securing ring must be re-determined later for installation and replaced.

• Carefully remove clutch. Make sure that clutch carrier or other clutch components do not fall out, therefore do not rotate clutch under any circumstances!

• If this has happened however, components can be assembled according to overview of clutch => [ Clutch Component Overview ] Clutch Component Overview.

- Completely remove clutch - A - in direction of - arrow -.





- Pull out input shaft - A - for transmission oil pump.





• Input shaft for transmission oil pump is inserted only after installing the new clutch. Set shaft aside until then.