Installation (from 07/2011)

C50 MANUAL TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL CABLE (for Hatchback): INSTALLATION

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Install the transmission control cable assembly with the 3 nuts.

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)

(b) Install the control select cable and control shift cable to cable bracket with the 2 new clips B.





Text in Illustration





(c) Install the control select cable and control shift cable to manual transaxle with the 2 clips A and 2 washers

2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Rotate the transmission control cable nut counterclockwise 180° and push in the lock while holding the nut.





Text in Illustration





(b) Install the transmission control cable's cable outer onto the shift lever plate.





Text in Illustration





NOTICE:
After installation, check that the cable outer lock extends past the line A-A, as shown in the diagram.

(c) Install the control shift cable to the shift lever assembly with the clip B.

(d) Install the control select cable to the shift lever assembly with the clip A.

NOTICE:
Install the cable end adjustment mechanism so that the lock faces the driver seat.

3. ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY Adjustments

4. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR

(a) Install the front No. 1 floor heat insulator with the 2 bolts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

5. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation (from 07/2011)

6. INSTALL FRONT FLOOR CENTER BRACE (w/ Side Mudguard) Installation (from 07/2011)

7. INSTALL AIR CLEANER CAP W/ AIR CLEANER HOSE Installation (from 07/2011)

8. INSTALL REAR CONSOLE BOX ASSEMBLY

Installation (from 07/2011)

9. INSPECT FOR EXHAUST GAS LEAK