Clutch Switch Circuit (from 07/2011)

CRUISE CONTROL: CRUISE CONTROL SYSTEM (for Hatchback): Clutch Switch Circuit
- Clutch Switch Circuit

DESCRIPTION

While depressing the clutch pedal, the clutch switch sends a signal to terminal 81 (D) of the ECM. The ECM cancels cruise control when terminal 81 (D) receives the signal.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. INSPECT NO. 2 CLUTCH START SWITCH ASSEMBLY

(a) Inspect the No. 2 clutch start switch assembly Testing and Inspection.

NG -- REPLACE NO. 2 CLUTCH START SWITCH ASSEMBLY Removal (from 07/2011)
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (NO. 2 CLUTCH START SWITCH ASSEMBLY - ECM AND BATTERY)

(a) Disconnect the A67 No. 2 clutch start switch assembly connector.

(b) Disconnect the C51 ECM connector.

(c) Measure the voltage according to the value(s) in the table below.





Standard Voltage:





Text in Illustration





(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures