Anti-Lock Brake System for Hatchback (from 07/2011)

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ANTI-LOCK BRAKE SYSTEM (for Hatchback): C1405, C1406: Open or Short in Front Speed Sensor RH Circuit
C1406 - Open or Short in Front Speed Sensor LH Circuit

DESCRIPTION

Refer to DTCs C1401 and C1402 Anti-Lock Brake System for Hatchback (from 07/2011).





HINT
* DTC C1405 is for the front speed sensor RH.
* DTC C1406 is for the front speed sensor LH.

WIRING DIAGRAM

Refer to DTCs C1401 and C1402 Anti-Lock Brake System for Hatchback (from 07/2011).

INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION)

(a) Using the Techstream, check for any momentary interruption in the wire harness and connector corresponding to the DTC Anti-Lock Brake System for Hatchback (from 07/2011).

ABS/VSC/TRAC





OK:

There are no momentary interruptions.

HINT
Perform the above inspection before removing the sensor and connector.

NG -- CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - FRONT SPEED SENSOR)
OK -- Continue to next step.

2. READ VALUE USING TECHSTREAM (FRONT SPEED SENSOR) Anti-Lock Brake System for Hatchback (from 07/2011)

NG -- CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - FRONT SPEED SENSOR)
OK -- Continue to next step.

3. RECONFIRM DTC

(a) Turn the ignition switch off.

(b) Clear the DTCs Anti-Lock Brake System (for Hatchback).

(c) Start the engine.

(d) Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.

(e) Check if the same DTC is recorded Anti-Lock Brake System (for Hatchback).

Result





HINT
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step Problem Symptoms Table (from 07/2011).

B -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal (from 07/2011)

A -- CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) Anti-Lock Brake System for Hatchback (from 07/2011)

4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - FRONT SPEED SENSOR)

(a) Turn the ignition switch off.

(b) Make sure that there is no looseness at the locking part and the connecting part of the connectors.

(c) Disconnect the skid control ECU connector and the front speed sensor connector.

(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





(e) Reconnect the skid control ECU connector and the front speed sensor connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. INSPECT SKID CONTROL ECU (SENSOR INPUT)

(a) Turn the ignition switch to ON.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





NOTICE:
Check the speed sensor signal after replacement Test Mode Procedure (from 07/2011).

HINT
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step Problem Symptoms Table (from 07/2011).

Text in Illustration





NG -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal (from 07/2011)

OK -- REPLACE FRONT SPEED SENSOR Removal (from 07/2011)