Anti-Lock Brake System (for Hatchback)

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ANTI-LOCK BRAKE SYSTEM (for Hatchback): DTC CHECK / CLEAR

1. DTC CHECK/CLEAR (When Using Techstream)

(a) Check the DTC.

(1) Turn the ignition switch off.

(2) Connect the Techstream to the DLC3.

(3) Turn the ignition switch to ON.

(4) Turn the Techstream on.

(5) Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.

(6) Check the details of the DTCs Anti-Lock Brake System (for Hatchback).

HINT
Refer to the Techstream operator's manual for further details.

(b) Clear the DTC.

(1) Turn the ignition switch off.

(2) Connect the Techstream to the DLC3.

(3) Turn the ignition switch to ON.

(4) Turn the Techstream on.

(5) Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.

(6) Clear the DTCs by following the prompts on the Techstream.

HINT
Refer to the Techstream operator's manual for further details.

2. DTC CHECK/CLEAR (When not Using Techstream)

(a) Check the DTC.





(1) Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST : 09843-18040

(2) Turn the ignition switch to ON.

(3) Observe the blinking pattern of the ABS warning light in order to identify the DTC.

HINT
If no code appears, inspect the TC and CG terminal circuit, and ABS warning light circuits.





Text in Illustration





HINT
* When the system is operating correctly, each light will blink continuously in a pattern of 0.25 seconds on, and then 0.25 seconds off.
* When one DTC is output, each light will output the same code at 4 second intervals (for example, code 21 would be output as 2 flashes, a 1.5 second pause, and then 1 flash).
* When 2 or more DTCs are output, each light will output a different code at 2.5 second intervals, and when all codes have been output, there will be a 4 second pause and the sequence will repeat.
* When multiple codes are stored, they are output in order starting with the lowest DTC number

(4) Check the details of the DTCs.

ABS DTC





(5) After completing the check, disconnect terminals TC and CG of the DLC3 to turn off the display.

HINT
If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

(b) Clear the DTC.

(1) Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.





SST : 09843-18040

(2) Turn the ignition switch to ON.

Text in Illustration





(3) Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

(4) Check that the warning light indicates a normal system code.

(5) Remove SST from the terminals of the DLC3.

HINT
Clearing the DTCs cannot be performed by disconnecting the battery terminal or the ECU-IG fuse.

3. END OF DTC CHECK/CLEAR

(a) Turn the ignition switch to ON.

(b) Check that the ABS warning light go off within approximately 3 seconds after turning the ignition switch to ON.