Installation

HEATING / AIR CONDITIONING: AIR CONDITIONING PRESSURE SENSOR: INSTALLATION

1. INSTALL AIR CONDITIONING PRESSURE SENSOR

(a) Sufficiently apply compressor oil to a new air conditioning pressure sensor.





Compressor oil:

ND-OIL 11 or equivalent

NOTICE:
* Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign objects.
* Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.

(b) Install the new air conditioning pressure sensor.

Torque : 11 Nm (110 kgf-cm, 8 ft-lbf)

NOTICE:
* Do not deform the piping.
* Make sure to confirm that the piping does not disengage from the plastic clamp.

(c) Connect the connector.

2. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. INSTALL REAR NO. 3 FLOOR BOARD Installation

4. INSTALL REAR DECK FLOOR BOX Installation

5. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) Installation

6. CHARGE WITH REFRIGERANT Service and Repair

7. WARM UP COMPRESSOR Service and Repair

8. INSPECT FOR REFRIGERANT LEAK Service and Repair