Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: REMOVAL

NOTICE:
* While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing the brake system components, do not depress the brake pedal or open/ close the doors while the battery is connected.
* When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.
* If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
* The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.

1. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type) Removal

2. REMOVE REAR DECK FLOOR BOX Removal

3. REMOVE REAR NO. 3 FLOOR BOARD Removal

4. DISABLE BRAKE CONTROL Removal

5. REMOVE REAR WHEEL

6. REMOVE FRONT DOOR SCUFF PLATE LH Removal

7. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal

8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Removal

9. LOOSEN PARKING BRAKE CABLE Removal

10. DISCONNECT REAR SPEED SENSOR WIRE

(a) Using a screwdriver, disconnect the connector from the rear speed sensor.

NOTICE:
Be careful not to damage the rear speed sensor.





11. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY Removal

12. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Replacement

13. REMOVE REAR DISC Removal

14. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

(a) Remove the rear axle hub and bearing assembly Removal.

HINT
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.