Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION ECU: INSTALLATION

1. INSTALL OCCUPANT CLASSIFICATION ECU

(a) Install the occupant classification ECU with the claw.





NOTICE:
If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant classification ECU with a new one.

(b) Connect the 2 connectors.

NOTICE:
When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.

2. INSTALL FRONT SEAT ASSEMBLY RH

HINT
* Use the same procedure for the RH side and LH side.
* Refer to the procedure from Install Front Seat Assembly Installation.

3. ZERO POINT CALIBRATION AND SENSITIVITY CHECK

(a) Perform zero point calibration and sensitivity check Programming and Relearning.

4. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check DTC Check / Clear.

5. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.