Installation

P314 HYBRID TRANSMISSION / TRANSAXLE: MOTOR CABLE: INSTALLATION

1. INSTALL MOTOR CABLE

CAUTION:
Wear insulated gloves.

NOTICE:
* Do not damage the terminals, connector housings or inverter with converter assembly when connecting them.
* Do not touch the connector waterproofing rubber or terminals.
* Do not allow any foreign objects or water to enter the inverter with converter assembly.

(a) Install the motor cable to the hybrid vehicle transaxle assembly with 4 new bolts.

Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)

(b) Connect the 2 clamps in the order shown in the illustration.





(c) Install the motor cable to the hybrid vehicle transaxle assembly with the bolt.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(d) Connect the clamp.

(e) Connect the motor cable to the inverter with converter assembly.

(f) Connect the 3 wire harness clamps.

(g) Using an insulated tool, install the motor cable to the inverter with converter assembly with the 3 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

NOTICE:
* The connector should be connected securely.
* The bolts should be fastened securely.

2. INSTALL UPPER INVERTER COVER Installation

3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation

4. INSTALL AIR CLEANER FILTER ELEMENT

5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation

6. INSTALL INLET AIR CLEANER ASSEMBLY Installation

7. INSTALL COOL AIR INTAKE DUCT SEAL Installation

8. INSTALL SERVICE PLUG GRIP

Installation