Installation

2AR-FXE INTAKE / EXHAUST: INTAKE MANIFOLD: INSTALLATION

1. SET INTAKE MANIFOLD

(a) Install the fuel vapor feed hose to the intake manifold.

(b) Install the vacuum hose to the intake manifold.

(c) Install the wire harness clamp bracket with the bolt.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(d) Install a new gasket to the intake manifold.

(e) Set the intake manifold on the engine assembly.

2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY Installation

3. CONNECT FUEL TUBE SUB-ASSEMBLY Installation

4. INSTALL INTAKE MANIFOLD

(a) Temporarily install the intake manifold with the 6 bolts.

(b) Tighten the 6 bolts in the order shown in the illustration.





Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)

(c) Connect the 6 wire harness clamps.

(d) Connect the heated oxygen sensor connector.

(e) Connect the No. 2 ventilation hose.

5. INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR Installation

6. INSTALL EGR VALVE ASSEMBLY Installation

7. INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY Installation

8. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Installation

9. INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY

Installation

10. CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

11. INSTALL LUGGAGE TRIM SERVICE HOLE COVER Installation

12. INSPECT FOR FUEL LEAK Fuel System