C1AB0

PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: C1AB0: Short to +B in Outer Mirror Indicator(Master)
C1AB0 - Short to +B in Outer Mirror Indicator(Master)

DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects a +B short in the outer rear view mirror indicator RH.








WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.

PROCEDURE

1. CHECK DTC

(a) Clear the DTCs Blind Spot Monitor System.

(b) Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.

NG -- INSPECT OUTER REAR VIEW MIRROR RH (OUTER REAR VIEW MIRROR INDICATOR RH)

OK -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting

2. INSPECT OUTER REAR VIEW MIRROR RH (OUTER REAR VIEW MIRROR INDICATOR RH)

(a) Disconnect connector O28 from the blind spot monitor sensor RH.

(b) Measure the voltage according to the value(s) in the table below.





Standard Voltage:









NG -- CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER REAR VIEW MIRROR RH)

OK -- REPLACE BLIND SPOT MONITOR SENSOR RH Removal

3. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER REAR VIEW MIRROR RH)

(a) Disconnect connector IND1 from the outer rear view mirror RH.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





NG -- CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR RH - OUTER REAR VIEW MIRROR ASSEMBLY RH)

OK -- REPLACE OUTER REAR VIEW MIRROR RH Removal

4. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR RH - OUTER REAR VIEW MIRROR ASSEMBLY RH)

(a) Disconnect connector J13 from the outer rear view mirror assembly RH.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE OUTER REAR VIEW MIRROR ASSEMBLY RH Removal