Installation

2AZ-FE ENGINE MECHANICAL: TIMING GEAR:

INSTALLATION

1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL
(a) Apply MP grease to a new oil seal lip.

NOTE: Keep the lip free from foreign matter.





(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
SST: 09223-22010

NOTE: Wipe off extra grease from the crankshaft.

2. INSTALL CRANKSHAFT PULLEY
(a) Align the pulley set key with the key groove of the pulley.





(b) Using SST, install the pulley bolt.
SST: 09960-10010
09962-01000
09963-01000
Torque: 180 Nm (1836 kgf-cm, 133 ft-lbf)
3. INSTALL FAN AND GENERATOR V BELT (Installation)

4. INSTALL ENGINE MOUNTING BRACKET NO.2 RH
Torque: 52 Nm (531 kgf-cm, 38 ft-lbf)
5. INSTALL ENGINE MOUNTING STAY NO.2 RH
Torque: 64 Nm (653 kgf-cm, 47 ft-lbf)
6. INSTALL ENGINE MOVING CONTROL ROD W/BRACKET





(a) Install the control rod with the 3 bolts.
Torque: 64 Nm (653 kgf-cm, 47 ft-lbf)
7. INSTALL FRONT WHEEL RH
8. CHECK FOR ENGINE OIL LEAKS