Engine Control System

DIAGNOSTIC TROUBLE CODES:
Your readings may vary from the parameters listed in the table, depending on the instruments used.

DTCs 12 Through 26:

DTCs 27 Through 71:

REMARKS:
*1: "ON" displayed in the diagnosis mode column indicates that the Malfunction Indicator Lamp is lit up when a malfunction is detected.
"OFF" indicates that the Malfunction Indicator Lamp does not light up during malfunction diagnosis, even if a malfunction is detected.
"N.A." indicates that the item is not included in malfunction diagnosis.

*2: "O" in the memory column indicates that a diagnostic code is recorded in the ECM memory when a malfunction occurs.
"X" indicates that a diagnostic code is not recorded in the ECM memory even if a malfunction occurs. Accordingly, output of diagnostic results in normal or test mode is performed with the ignition switch ON.

*3: The Malfunction Indicator Lamp comes on if malfunction occurs ONLY to California specifications.

*4: Code 26, 27 is used ONLY for California specifications.

*5: "2 trip detection logic".