Diagnostic Procedure 2

Trouble Diagnosis with CONSULT-II

DIAGNOSTIC PROCEDURE 2
Refer to GI-37, "CONSULT-II Start Procedure". With Manufacturer's Scan Tool

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.




1. Touch "SELF-DIAG [CURRENT]".




2. Diagnostic code is displayed on "SELF-DIAG [CURRENT]".




3. If no malfunction is detected on "SELF-DIAG [CURRENT]" even though malfunction is detected in "SRS Operation Check", check the battery voltage. If the battery voltage is less than 9 V, charge or replace the battery. Then go to SRS-27, "DIAGNOSTIC PROCEDURE 3". Diagnostic Procedure 3 If the battery voltage is OK, go to SRS-29, "DIAGNOSTIC PROCEDURE 4 (CONTINUED FROM DIAGNOSTIC PROCEDURE 2)" to diagnose the following cases: Diagnostic Procedure 4 (Continued From Diagnostic Procedure 2)
- Self-diagnostic result "SELF-DIAG [PAST]" (previously stored in the memory) might not be erased after repair.
- The SRS system malfunctions intermittently.

DTC No. Index ("Self-Diag [Current]" (Part 1):

DTC No. Index ("Self-Diag [Current]" (Part 2):

DTC No. Index ("Self-Diag [Current]" (Part 3):

DTC No. Index ("Self-Diag [Current]" (Part 4):

DTC No. Index ("Self-Diag [Current]" (Part 5):

DTC No. Index ("SELF-DIAG [CURRENT]")