Operation CHARM: Car repair manuals for everyone.
Hosted by mcallihan.com
Home >> Honda >> 2012 >> CR-Z L4-1.5L Hybrid >> Repair and Diagnosis >> Accessories and Optional Equipment >> Radio, Stereo, and Compact Disc >> Testing and Inspection >> Component Tests and General Diagnostics >> Speaker Test/Replacement

Speaker Test/Replacement




Speaker Test/Replacement

Front Door Speaker

1. Remove the door panel Door Panel Removal / Installation.

2. Remove the bolt (A). Then lift the speaker (B) straight up to release the lower clips.

NOTICE
If you pull the speaker out too far from the door, you will damage the lower clips.





3. Disconnect the 2P connector (C), and remove the speaker.

4. Measure the resistance between terminals No. 1 and No. 2. There should be about 4.0 Ohms.

5. If the resistance is not as specified, replace the door speaker.

6. Install the speaker in the reverse order of removal.

Rear Speaker

1. Remove the rear speaker grille (A) from the rear side trim panel.






2. Remove the bolt (A). Then lift the speaker (B) straight up to release the lower clips.

NOTICE
If you pull the speaker out too far from the trim, you will damage the lower clips.






3. Disconnect the 2P connector (C), and remove the speaker.

4. Measure the resistance between terminals No. 1 and No. 2. There should be about 4.0 Ohms.

5. If the resistance is not as specified, replace the rear speaker.

6. Install the speaker in the reverse order of removal.

Tweeter

NOTE:

- Be careful not to damage the tweeter grille and the dashboard.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

1. Carefully pry the tweeter grille (A) out of the dashboard.






2. Disconnect the 2P connector (B) from the tweeter.

3. Remove the tweeter (A) from the tweeter grille (B).






4. Check the capacitor condition. If any malfunction is found, replace the tweeter.

5. Measure the resistance between the tweeter (A) terminal No. 2 and the outside terminal of the capacitor. There should be about 4.0 Ohms.






6. If the resistance is not as specified, replace the tweeter.

7. Install the tweeter in the reverse order of removal.

Subwoofer

1. Remove the rear side trim panel Interior Trim Removal / Installation - Cargo Area.

2. Disconnect the 2P connector (A). Remove the mounting bolts (B) and nut (C), then remove the subwoofer (D).






3. Measure the resistance between terminals No. 1 and No. 2. There should be about 2.3 Ohms.

4. If the resistance is not as specified, replace the subwoofer.

5. Install the subwoofer in the reverse order of removal.

pro multis · About Operation CHARM