Interior Trim Removal / Installation - Cargo Area
Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857
NOTE:
- Put on gloves to protect your hands.
- Take care not to bend or scratch the trim or the panels.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Remove the tonneau cover (A).
2. Remove the rear tray Interior Trim Removal / Installation - Rear Tray Area.
3. Remove the cargo floor lid (A).
4. Remove the spare tire.
5. Remove the cargo floor side boxes (A).
6. Pull up the IPU duct cover (A) by hand to detach the clips and the hooks (B), then remove the IPU duct cover.
7. If necessary, remove the bolts, then remove the spare tire beam (A).
8. Remove the hatch weatherstrip as needed.
9. Remove the rear trim panel (A).
1. Detach the hooks (B, C) on both sides from both rear side trim panels (D).
2. Pull up the rear trim panel by hand to detach the clips.
10. Remove these items:
- Rear tray light Rear Tray Light Replacement
- Door opening seal as needed
- Hatch weatherstrip as needed Service and Repair
11. Remove the rear side trim panel (A).
1. Pull out the top of the trim by hand to detach hooks (B) from the center pillar trim (C) and the rear pillar trim (D).
2. Release the pin (E) of the rear edge of the trim panel from the hole in the body.
3. Pull back the trim panel by hand to detach the clips (F, G, H) and clips (I) ('12 model).
4. Disconnect the cargo area light connector (J) on the left side.
12. If necessary, remove the quarter hole seal (A).
1. Remove the rear speaker.
2. Detach the harness clip (B).
13. Install the trim in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips, the hooks, and the pin into place securely.
- Left side: Make sure the cargo area light connector is plugged in properly.